Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 25)

2-12 Programmer’s Manual
Boot Options
When DOS begins loading, you have the following options for
processing CONFIG.SYS and AUTOEXEC.BAT:
♦
Bypass the files
♦
Be prompted whether to process each line of both files
♦
Process every line of both files.
To choose the boot options:
1. Turn on the printer while holding f down until messages
appear. You must do this step. Otherwise, the date and
time prompts (the default) wait for input without appearing
on the screen.
2. When “Starting ROM-DOS…” appears, the printer beeps.
You have approximately two seconds to do one of the
following:
♦
Press f, then 5 to bypass both files. The boot
process continues with default configurations. The
printer also prompts you for the date and time.
♦
Press f, then 8 to request a prompt at each line of
both files. Enter Y to process the line or N to bypass it.
♦
Do nothing and let the printer process every line of both
files.
Booting from the PC
To boot the printer from the PC:
1. Gather the necessary boot files (see “Creating Disk
Images” in Chapter 3) on a floppy disk or the root partition
of a non-booting hard drive.
2. Run REMSERV from the PC, using the boot files’ location
as the shared drive.