Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 39)

3-12 Programmer’s Manual
Recovering from a Disk Image Loading Problem
If the cable connection becomes broken, re-establish the
REMSERV/REMDISK link and start over. If this action fails or
you lose power, the disk image is corrupt and you must boot the
printer from the PC. If the disk images in both flash ROMs
become corrupt, you must return the printer to Monarch for
service. See “Booting from the PC” in Chapter 2 for
information.
E x i t i n g R E M S E R V a n d R E M D I S K
To quit REMSERV:
1. Change the printer’s current drive to one other than the
shared PC drive.
2. Press any key on the PC. Or, enter the REMQUIT
command on the printer (if you included that utility in the
disk image). The printer can no longer access the drive
until you restart REMSERV.
To quit REMDISK, run it again with the /U option. See
“REMDISK” in Chapter 7 for more information.
T e s t i n g t h e A p p l i c a t i o n A w a y f r o m t h e P C
It is good practice to re-test your application when you have
loaded it into the printer and the printer is detached from the
PC.
T r a i n i n g t h e E n d U s e r s
The last step in the development of an application is to train the
end users (Operators) and/or their supervisor (System
Administrator). Depending on the application’s complexity, this
training may include a class, written instructions, or any other
appropriate format.