Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 26)

Printer Features 2-13
3. Turn on the printer while holding a down until boot
messages display. The printer mounts a backup drive (A:)
in memory. The printer beeps twice when it starts to boot
from the PC. The booting continues using the default
configurations. The printer also prompts you for the date
and time.
The PC boot drive becomes drive B: on the
printer.
W i n d o w s 9 5 / N e t w o r k N o t e s
Directory Names
The printer does not recognize directory names longer than 8
characters, not including the extension.
Copying Data from the Printer to PC
The procedure to copy data from the printer to a PC varies,
depending on your system.
FAT32, NTFS, and Networks
1. Copy the file from the printer to a diskette.
2. Copy the file from the diskette to the PC’s hard drive.
FAT16 File Systems
1. Reboot your PC in DOS mode. You must reboot. For this
procedure to work, you cannot go to the DOS shell.
2. Connect the cable between the PC and the printer.
3. Lock the PC’s hard drive by entering the DOS lock
command at the DOS prompt. Enter Y at the “Are You
Sure (Y/N)?” prompt.
4. Run Remserv on the PC, specifying the locked drive.
5. Run Remdisk on the printer.