Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 72)

Function Reference 4-31
{
if (!pclBatteryOkToPrint()) // Check battery
printf("Battery too low");
else
{ // Write format
strcpy(cFormat, "{F,1,A,R,E,400,200, \"1C39\"|");
strcat(cFormat, "B,1,12,F,320,29,4,12,20,8,L,0|");
strcat(cFormat, "R,1, \"666666666666");
strcat(cFormat, "\"|}");
sStatus = pclWrite(cFormat, strlen(cFormat));
if (sStatus != 0)
printf("Format Write error - %d", sStatus);
else
{ // Start batch
sStatus = pclWrite("{B,1,N,1|E,0,0,1,1,0,1|}", 24);
if (sStatus != 0)
printf("Batch Write error - %d", sStatus);
else
{
while ((sStatus = pclStatus()) == 1) // Wait until done
;
sStatus = pclGetOnDemandSensor(); // Check sensor
switch (sStatus) // Display result
{
case 0: printf("\nNot blocked");
break;
case 1: printf("\nBlocked");
break;
default: printf("Error-- press any key w hen reset.");
_getch();
pclClearError();
}
}
}
}
}
pclClose(); // Close Print subsystem
}