Avery Dennison Monarch 9860 Operator Handbook - Manual (Page 71)

R e s e t t o D e f a u l t Va l u e s
To change the setting, from the Main Menu select Setup, Port
Settings, then Serial Comm. Then, follow these steps.
1. Press r until you see
SERIAL COMM
l
Reset
2. Press N.
Are you sure?
No
r
3. Press l or r to make your selection, then press N. If you
select "Yes," the following defaults are restored: 9600 baud,
No parity, 8 bit word length, and 1 stop bit.
4. Press E until you see the Main Menu.
Pa r a l l e l C o m m u n i c a t i o n s
The parallel communications menu allows you to set the values
for the active parallel port. The values are listed in the table
below.
Option Choices Default
Port External/Internal External
Mode Compatible/IEEE-1284 Compatible
(Centronics mode)
Communication Values
8-5