Avery Dennison Monarch 9860 Operator Handbook User Manual
Page 55
K n i f e C o n t r o l
You may notice unevenly cut tags on one end or the other of your
supply (one end may appear longer than the other). Use the knife
control adjustment to balance the cut tag length from tag-to-tag.
You may need to make this adjustment
◆
on initial printer setup.
◆
if you load a different supply type (thickness) from the last
ones printed.
◆
when you change the print speed.
◆
when you change to a different tag size from the last ones
printed.
To change the setting, from the Main Menu, select Setup, then
Supply. Then, follow these steps.
1. Press l or r until you see
SUPPLY
l
Knife Ctrl
2. Press
N. The current setting is displayed, for example:
Enter knife ctrl
[-20/20]: +0
3. Press l or r to change the knife control. You may need to
experiment and cut a few test tags to check the tag cut
length. Pressing
l decreases the value; r increases it.
Before Knife Control
After Knife Control
Setting Supply Options
6-17