Avery Dennison Monarch 9860 Operator Handbook - Manual (Page 35)

Use the following steps to customize which prompts appear
during batch entry and to specify defaults for these prompts.
1. Press N at the Main menu, when you see Batch Options. If
you have password protection enabled, you will see
Enter Password:
_ _ _ _ _ _ _
2. Press F three times and then press N. See Chapter 12,
"Diagnostics and Troubleshooting" for more information about
password protection.
Clear Fields?
Prompt? Yes
3. Decide if you want to see this prompt in Batch Entry mode
and press either l or r to display your selection. Press
N.
Clear Fields?
No
r
4. Decide if you want to change the default (No) and press
either l or r to display your selection. Press N.
Number of parts
Prompt? Yes
5. Decide if you want to see this prompt in Batch Entry mode
and press either
l or r to display your selection. Press
N.
Number of parts
[1/5]: +1
6. Decide if you want to change the default (1) part printed
across the supply. Press
r to change the number of parts
(1-5). Press N.
Setting Batch Options
5-3