AMETEK 2003RP - Manual (Page 22)

3 Installation and Functional Test
3.1 Unpacking
Inspect the unit for any possible shipping damage immediately upon receipt. If damage is
evident, notify the carrier. DO NOT return an instrument to the factory without prior approval.
Do not destroy the packing container until the unit has been inspected for damage in
shipment.
3.2 Power Requirements
The AC Power System has been designed to operate from a single phase AC line voltage.
The nominal operating voltage is either 107/115V or 208/230V line input. The 2003RP line
input setting is shown on the type label located on the rear panel.
Figure 3-1: Model 2003RP AC Power Source
WARNING:
Do not connect the unit to AC line input unless the nominal line input settings
match those of the available AC line voltage.