beautypg.com

AMETEK 2003RP User Manual

Page 100

background image

[SOURce:]VOLT:RANGe:AUTO

This command sets the AC source range to the AUTO mode. While in AUTO mode, the AC
source automatically switches to the optimal voltage range for the voltage programmed.
Note that switching voltage ranges causes the output to be interrupted momentarily. If power
to the unit under test cannot be interrupted, the AUTO range should not be used.

To determine the actual voltage range in which the unit is operating, the VOLT:RANG?
command query can be used.

For 2003RP-AV models configured for single voltage range, only one range is available. In
this case, the VOLT:RANGe:AUTO command has no meaning and should not be used.

The maximum current limit that can be programmed at a given time depends on the voltage
range setting in which the unit is presently operating. Programming a current limit value that
exceeds the high voltage range capability does NOT cause the voltage range to change,
even while in AUTO mode. Only voltage changes can prompt an automatic voltage range
change.

Command Syntax

[SOURce:]VOLTage:RANGe:AUTO

Parameters

0 | 1

*RST Value

0

Examples

VOLT:RANG:AUTO 1

Query Syntax

VOLT:RANG:AUTO?

Returned Parameters

Related Commands

VOLT

LIM:VOLT?

VOLT:RANG:LEV

10.6 Output Subsystem

This subsystem controls the main output function of the RP Series source.

Subsystem Syntax

OUTPut

[:RELay]

Opens or closes the output relay.

:DROP

Drops the output voltage for a specified amount of time or
indefinitely.

STARt:

[STATe]

Enables or disables the start phase angle mode

PHASe

Sets the start phase angle value in degrees.


OUTPut[:RELay]

The output of the AC source can be isolated from the unit under test by opening the output
relay. The programmed output voltage is set to zero before opening the relay and is returned
to its programmed value when closing the relay. This avoids hot switching the output relay
contacts.

Command Syntax

OUTPut[:RELay]

Parameters

0 | 1

*RST Value

defined by the PONS

Examples

OUTP 1

Query Syntax

OUTPut?

Returned Parameters

0 | 1

Related Commands

OUTP:DROP

OUTP:STAR