AMETEK 2003RP - Manual (Page 17)

Parameter Specification Unit
Power Factor
Range 0.00 - 1.00
Accuracy 0.05
Resolution 0.01
2.4 System Specification
Parameter Specification
Setup storage Eight non-volatile front panel setup registers available through
interface. Power-on setting register available from front panel.
Interface (Option package -OP1 required)
RS-232C Bi-directional serial interface
Handshake: CTS, RTS
Data bits: 8
Stop bits: 1
Parity: None
Baud rate: 19200
Command syntax: IEEE 488.2 commands and SCPI
IEEE-488 GPIB Interface
IEEE address: set using dip switch on rear panel from
0 to 31
IEEE functions: SH1, AH1, T6, L3, RL2
Terminators: LF, CRLF, EOI
Command syntax: IEEE 488.2 commands and SCPI
Remote Inhibit (Option package -OP1 required)
Input Contact closure to ground or logic low TTL
signal required to turn off output.
Automatic recovery when RI signal is
removed.
Function Strobe (Option package -OP1 required)
Output Active low TTL signal. Signal driven low
for approximately 400 sec any time
output voltage or frequency programmed
value changes. Signal level may be
changed by removing jumpers to open
collector.