D-Link KX-TDA100 - Manual (Page 7)

Installation Manual 7
Precaution
• Keep the unit away from heating appliances and electrical noise generating devices such as fluorescent
lamps, motors and televisions. These noise sources can interfere with the performance of the Hybrid
IP-PBX.
• This unit should be kept free of dust, moisture, high temperature (more than 40 °C) and vibration, and
should not be exposed to direct sunlight.
• Never attempt to insert wires, pins, etc. into the vents or other holes of this unit.
• If there is any trouble, disconnect the unit from the telephone line. Plug an SLT into the telephone line.
If the telephone operates properly, do not reconnect the unit to the line until the trouble has been
repaired by an authorised Panasonic Factory Service Centre. If the telephone does not operate
properly, chances are that the trouble is in the telephone network, and not in the Hybrid IP-PBX.
• Do not use benzene, thinner, or the like, or any abrasive powder to clean the cabinet. Wipe it with a soft
cloth.
For users in Germany only
• When the unit is working, the noise is less than 70 dB (A) according to DIN 45635 Part 19.
For users in Finland, Norway and Sweden only (KX-TDA100/KX-TDA200 only)
• This unit may only be installed in a room or space with restricted access, and equipotential bonding
must be applied. For information on earthing, refer to "2.2.5 Frame Earth Connection".
For users in New Zealand only
• This equipment shall not be set to make automatic calls to the Telecom '111' Emergency Service.
• The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted
that the item complies with minimum conditions for connection to its network. It indicates no
endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides
no assurance that any item will work correctly in all respects with another item of Telepermitted
equipment of a different make or model, nor does it imply that any product is compatible with all of
Telecom's network services.
• This equipment is not capable, under all operating conditions, of correct operation at the higher speeds
for which it is designed. Telecom will accept no responsibility should difficulties arise in such
circumstances.
• Some parameters required for compliance with Telecom's Telepermit requirements are dependent on
the equipment (PBX) associated with this modem. In order to operate within the limits for compliance
with Telecom's Specifications, the associated PBX equipment shall be sent to ensure that modem calls
are answered between 3 and 30 seconds of receipt of ringing.
• IMPORTANT NOTICE
Under power failure conditions, the wireless telephones may not operate. Please ensure that a separate
telephone, not dependent on local power, is available for emergency use in emergencies.
For users in Australia only
• No External TRC Terminal is provided due to an Internal Link between PE and TRC.
WARNING
• THIS UNIT MAY ONLY BE INSTALLED AND SERVICED BY QUALIFIED SERVICE
PERSONNEL.