D-Link KX-TDA100 User Manual
Page 234
4.1 Troubleshooting
234
Installation Manual
023
System data file
version error
•
Old system files on SD
Memory Card
•
Defective system files on
SD Memory Card
•
Restore the backup files
•
Re-install the software
024
System initialization
file version error
025
Card initialization file
version error
026
LCD file version error
027
System data file
checksum error
028
System initialization
file checksum error
029
Card initialization file
checksum error
030
LCD file checksum
error
031*
System data file not
found
•
SD Memory Card not
installed
•
Bad connection of SD
Memory Card
•
SD Memory Card
malfunction
•
MPR card malfunction
•
Press the Reset Button
•
Reprogramme the Hybrid IP-PBX
•
Replace the SD Memory Card
•
Replace the MPR card (be sure to turn
off the Hybrid IP-PBX when replacing)
032*
System initialization
file not found
033*
Card initialization file
not found
034*
LCD file not found
035
System data file
access error
036*
System initialization
file access error
037*
Card initialization file
access error
038*
LCD file access error
039*
SD file access error
090
Over Card Limitation •
Too many optional service
cards installed
•
Reduce the number of optional service
cards
091*
PT connection over
•
Too many PTs connected
•
Reduce the number of PTs
092*
CS connection over
•
Too many CSs connected •
Reduce the number of CSs
200
LPR start up error
(ROM NG)
•
Optional service card
malfunction: DHLC, DLC,
CSIF, T1, E1, BRI, PRI,
OPB3, CTI-LINK, E&M,
IP-GW, DID, SLC8
•
Pull out and re-insert the
corresponding optional service card
•
Press the Reset Button
•
Replace the corresponding optional
service card
201*
LPR start up error
(RAM NG)
Error Code
Error Message
PROBABLE CAUSE
SOLUTION