D-Link KX-TDA100 - Manual (Page 219)

3.3 Installation of the KX-TDA Maintenance Console
Installation Manual 219
1. Connect the PC to the Hybrid IP-PBX with a USB cable.
2. Start the KX-TDA Maintenance Console from the Start
menu.
3. Type the Installer Level Programmer Code (default: 1234),
then click [OK].
The Programmer Code authorises different programming
levels, and the Quick Setup is only available when you start
the KX-TDA Maintenance Console with the Installer Level
Programmer Code.
Note
There are 2 other Programmer Codes with limited
authorisation: Administrator Level (default: 1111), and
User Level (default: none).
4. Click "Connect" "USB" from the menu bar.
5. Type the system password for installer (default: 1234), then
click [OK] to log-in.
6. When country/area data do not match:
a. Click [OK] to replace the country/area data of the
Hybrid IP-PBX. Replacement may take several
minutes to complete.
b. Follow the procedure described in "2.13.1 Starting the
Hybrid IP-PBX" and restart the Hybrid IP-PBX.
c. Repeat steps 2 to 5 to restart the KX-TDA
Maintenance Console.