D-Link KX-TDA100 - Manual (Page 209)

2.13 Starting the Hybrid IP-PBX
Installation Manual 209
2.13 Starting the Hybrid IP-PBX
2.13.1 Starting the Hybrid IP-PBX
CAUTION
• SD Memory Card must be inserted in the SD Memory Card slot of the MPR card before start up.
• Before touching the System Initialise Switch, discharge static electricity by touching ground or
wearing an earthing strap.
• Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do not perform the
following procedures to start the Hybrid IP-PBX again. Otherwise, your programmed data is
cleared. To restart the Hybrid IP-PBX, refer to "4.1.4 Using the Reset Button".
• The Hybrid IP-PBX will continue to be powered even if the power switch is turned "OFF".
• The power supply cord is used as the main disconnect device, ensure that the socket-outlet is
located/installed near the equipment and is easily accessible.
1. Set the System Initialise Switch to the "SYSTEM INITIALIZE" position.
System Initialise Switch
Reset Button
SYSTEM
INITIALIZE
RESET
NORMAL
RUN Indicator