Adtec digital Soloist-HD Pro (version 02.07.09) Manual - Manual (Page 73)

This General Public License does not permit incorporating your program into proprietary programs. If your
program is a subroutine library, you may consider it more useful to permit linking proprietary applications
with the library. If this is what you want to do, use the GNU Library General Public License instead of this
License.
Appendix B - Media Encoding Parameters
When creating content for the Soloist HD Pro, you need so ensure that your encoding parameters match
the decoder for best results.
MPEG 2 Encoding
Creating MPEG2 files, it is recommended to use the following parameters:
Multiplex Type: MPEG2 Transport Stream
Transport Steam composition:
● The file should start with a transport sync byte (0x47) and should maintain packet alignment
throughout the entire duration.
● There should be a minimal amount of fill packets at the start of the file.
● The first non-fill packet should be the PAT packet.
● The next non-fill packet should be the PMT packet(s).
● The next non-fill packet should be the first video stream packet.
● The first video stream packet should contain the following:
■ Adaptation indicator marking the presence of a PCR.
■ The adaptation flag field should have the discontinuity indicator set.
■ Valid PES header with PTS and DTS.
■ Valid video sequence header and GOP header.
● Use the following recommended PID values:
PMT: 0x1e0 (480dec)
PCR: 0x1e1 (481dec, must reference video PID)
Video: 0x1e1 (481dec)
Audio1: 0x1e2 (482dec)
Audio2: 0x1e3 (483dec)
Audio: 192Kbps AC-3 or MPEG Layer 2
HD Content:
● Resolution: High Profile up to 1920x1080 (1080i60 or 1080i50) Note that 1080i60 is not supported
● Bit Rate: 25Mbps constant bit rate (CBR).
SD Content:
● Resolution: Main Profile up to 720x480 NTSC or 720x576 PAL
● Bit Rate: 8Mbps constant bit rate (CBR)