Chapter 4 - how-to guides, Connecting to the soloist hd pro digital player, Telnet connection – Adtec digital Soloist-HD Pro (version 02.07.09) Manual User Manual
Page 40: Serial connection, Chapter, Guides, Connecting, Soloist, Digital, Player
Chapter 4 - How-To Guides
Connecting to the Soloist HD Pro Digital Player
Before you configure your player, you will need to establish a connection.
The default IP for the Soloist HD Pro is 192.168.10.48.
Telnet Connection
To connect to your Soloist HD Pro player using a Telnet connection, attach your Soloist HD Pro to your
local network and launch a telnet session. Logon with the username adtec and password none . Once you
are connected, you can control and monitor the unit by using the API commands. For a complete list of
API commands, point a web browser to the IP Address of your Soloist HD Pro and view the Adtec API
notes.
Serial Connection
To use a serial connection with your Soloist HD Pro, use the terminal kit included with your purchase. This
terminal kit contains a standard ethernet cable and a serial 9 pin adapter, aka “RS232 connector.” Plug
the ethernet cable into the back of your Soloist HD Pro using the port labeled COM2. The other end of the
ethernet cable should be plugged into the 9 pin adaptor. The adapter should then be connected to your
computer via the RS-232 port or with the use of a USB converter cable (not included).
Note: Please note that the use of a USB converter may not always provide connectivity. A setup disk or
drivers from the USB convertor manufacturer may be needed. You can also use a serial connection utility
such as Teraterm or PuTTY.