Adtec digital Soloist-HD Pro (version 02.07.09) Manual - Manual (Page 36)

Control Function Options API Command
Uptime this readout reports the amount of
time the unit has been running since
the last reset or power-on cycle
None (read only) *.SYSD UPT
Device Name the host name for the unit for
identification and networking
purposes.
When a unit is manufactured, it is
given a name that
combines the product type and the
serial number of the
unit
user-defined text field *.SYSD NAM
Gateway
Address
the IP assignment of the
gateway/router on your network;
limited to one address on Adtec
devices
text field; valid IP address in
form xxx.xxx.xxx.xxx
*.SYSD GIP
DHCP check box; allows unit to extract it's
own IP address, if
switched on, from a DHCP server
checked = On
not checked = Off *.SYSD DHC
Ethernet
Address
(Eth 0)
IP address of the unit's Control-
Ethernet (eth0) port
10/100mbps
text field; valid IP address in
form xxx.xxx.xxx.xxx *.SYSD IPA 0
Subnet Mask
(Eth 0)
Subnet mask address of the unit's
Control-Ethernet port
text field; valid IP address in
form xxx.xxx.xxx.xxx
*.SYSD IPM 0
GigE Address
(Eth 1)
IP address of the unit's GigE (eth1)
port 10/100/1000mbps.
Recommended that the GigE Port be
used as a MPEG2 or RTP multicast
receive port
text field; valid IP address in
form xxx.xxx.xxx.xxx
*.SYSD IPA 1
Subnet Mask
(Eth 1) Subnet mask address of the unit's
GigE port text field; valid IP address in
form xxx.xxx.xxx.xxx *.SYSD IPM 1
NTP Address IP Address of a Network Time
Protocol server text field; valid IP address in
form xxx.xxx.xxx.xxx *.SYSD NIP
Time Zone designates the time zone the unit is
operating in the offset is in hours
from UTC and a Daylight Savings
Setting
text field;
field requires very specific
input to be configured
correctly. Please refer to the
API Note for additional details *.SYSD TIZ
Date sets the units internal calendar/date
function. Visual calendar available
for point-and-click date setting.
text field;
Format: MM/DD/YYYY *.SYSD TIM
Time sets the unit's internal time clock.
Will auto-populate if unit is
networked to an NTP Server if
enabled.
text field;
24 Hour Clock format:
HH:MM:SS *.SYSD TIM