Adtec digital Soloist-HD Pro (version 02.07.09) Manual - Manual (Page 22)

Set-up a Display Target
Step Action
1 Press the button until DECODER MENU is displayed on the LCD screen, then
press .2Press the arrow until Display Target is displayed on the LCD screen.3To change the output display resolution, press and navigate to the desired
video resolution setting, and then press to save.
Note: The display target setting is the output resolution and refresh rate used
simultaneously on both the HDMI, SDI and the composite BNC video outputs.
Therefore, to view video on the composite BNC output port, select one of the NTSC or
PAL display targets.
2 Press the arrow until Display Target is displayed on the LCD screen.
3 To change the output display resolution, press
Make Connections
Connect: Make the following general cable connections for your setup:
Cable Connection
Video Connect a video or Composite monitor to the correct SDI, HDMI or
the composite BNC connector.
Analog Audio Connect Analog Left and Right RCA Cable to display unit
Digital Audio Connect RCA Digital Audio Cable to Digital Audio Decoder
Ethernet Ethernet: Connect an Ethernet cable to the Ethernet port for
external control.
Confirm: Plug in the Adtec Soloist HD Pro and confirm that the IP address is correct on your unit, and
that the Link LED on the front of the unit is lit before using Adtec's web-based control application.