beautypg.com

Installation, Set-up an ip address, Address – Adtec digital Soloist-HD Pro (version 02.07.09) Manual User Manual

Page 21

background image

COM1

Terminal monitor connection port for diagnostic access to unit's motherboard.

default 115200 bps

COM2

RS232 connection port for API control. default 38400 baud

ETH 10/100
(eth0)

10/100 base T ethernet interface; 2 LED indicators
Link- device networked
Busy- traffic on interface

USB 2.0

Not currently supported / Reserved for future use

SPDIF OUT

Sony/Phillips Digital Interface; compressed digital audio transport

Balanced Stereo

Audio Out

Six balanced, 600 Ohm outputs on three 5-pin mini-RST connectors

DVC PARPORT

Parallel IO Interface for Start, Stop, Status, Alarm, and general purpose

interfacing to control systems

POWER

AC Power- standard 3-pin plug (70-240 VAC 50-60 Hz)

Installation

One Soloist HD Pro server can be installed into a one-rack unit 19” rack slot. Power should be applied to
the unit and configured with a valid IP address and display target via the front panel.

Set-up an IP Address

Step

Action

1

Press the button until SYSTEM MENU is displayed on the LCD screen, then
press

3

Press the arrow until Ethernet IP Address item is shown on the LCD screen.

4

Enter the IP address desired for the unit using the .

6

Enter the IP Mask using the