Adtec digital Soloist-HD Pro (version 02.07.09) Manual - Manual (Page 55)

Factory Reset / Restore
At times, it may be desirable to factory restore / default your unit to the original configuration it had when
it was new. On the
Upgrade Tab , you will find a list of the currently installed firmware in the ‘Available
Firmware Versions’ list. Your currently installed firmware version will have the distinction of
(***current selection***) to the right of the version number.
Image reduced for clarity
To restore the unit to its’ factory defaulted configuration, click the Restore Button to the
right hand side of the currently selected version. The unit will give another popup window asking for
confirmation and that the unit will reboot. Click Ok to complete the Restore function.
Once the restoration is in progress, you may receive a popup window stating a “Script Error.” Just select
to stop the script and close the browser.
Before reconnecting to the unit, it is recommended to clear the History / Cache from the browser that you
are using. Once complete, reconnect to the unit and continue with setup, operation or troubleshooting.
Playback Prioritization
The Soloist HD Pro will give decode priority to certain configurations over others.
Priority, In order:
1. DVB-ASI Recieve
2. Scheduled Playback
3. IP Mulitcast / Unicast Receive
4. List Playback
This means that a scheduled event will take precedence over playing from a list or decoding an IP Stream.