Adtec digital TBGS w/adManage - Manual (Page 9)

7 Chapter 2 - Getting Started
Email Host: The SMTP outgoing email host that should be used by adManage
to send emails to this user. Note that typically the same SMTP host can be
used for all users on the system.
Email Address: Email address for the user. This email address will be used
by the Alarm Service.
Requires Authentication: Indicates whether the SMTP server requires user
name and password authentication for sending emails using that host.
User Name: The SMTP server user name to use for authentication when
adManage sends emails.
Password: The SMTP server password to use for authentication when
adManage sends emails.
The following fields are available for any pager device available to that user.
Pager ID: Phone number for the paging terminal service used. Please check
with your pager provider for the terminal service telephone number which
should be used.
Pager Phone Number: Pager phone number for the user’s paging device.
Baud: Select the rate of data transmission specific to the pager. (Bits per
second. 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200,
172800, 345600, 518400, 1036800)
Parity: Select the error checking bit specific to the pager. (None, Odd, Even,
Mark, Space)
Type: Designate whether the pager is an alphanumeric or numeric pager.
Length: The maximum number of characters which can be received by a text
pager. (80, 120 characters).
Stop Bits: A stop bit signals the end of the data message to a paging
terminal. Select the stop bits specific to the pager. (1 , 2)
Data Bits: Data bits are the number of bits that hold the data to be
transferred over a modem connection to a pager terminal. Select the data bits
specific to the paging terminal. (7 , 8)
Delay: The paging terminal service delay in seconds.
Modem Comport: The serial communication port of the server which is used
to connect with the telephone modem. (Typically COM1).
Once you have added a user it is possible to edit or delete that
user by browsing to Configuration > Users and selecting either Edit or
Delete to proceed.