Adtec digital DPI-1200 (version 01.04.08U) Manual - Manual (Page 23)

channel
GPI Time
Changed Displays the time the
most recent GPI
trigger received for a
channel Non-editable display, status only.
Displayed in the format: Weekday
Hour:Minutes:Seconds:Milliseconds
(Day HH:MM:SS.mmm) *.DPID GHS #
TIMENEW
GPO State Sets condition of port
state for trigger
reception OPEN Port is normally open
CLOSED Port is normally closed
(Front Panel Only Configuration) *.DPID GPO #
DTMF
Speaker Routes a given input
tone source to the
speaker on the
DTMF board ON Turns on speaker for DTMF
Tone for channel
OFF Turns off the speaker for the
channel *.DPID SRP #
Note: Up to twelve Insertion Channels are available on the product. If using API
Commands, the ‘#’ denoted in the commands above are relevant to the twelve channel
destinations indexed 0 - 11.
Back Panel Diagram
The back panel contains the ports and connection points for the device.
Connections
Connection Function
AC Power AC Power- standard 3-pin plug (70-240 VAC 50-60 Hz), 5Vdc Power
(x2) - External Power Only
GigE GigeE Interface - MPTS Output over UDP / Management
Firewire FireWire Reserved for future use
Terminal Monitor API Serial Communication Interface / Serial Port used for
Troubleshooting
Fast Ethernet 10/100 base T-Ethernet interface
RS232 DB9; Used to communicate with redundancy switch (ASI Model Only)