Adtec digital DPI-1200 (version 01.04.08U) Manual - Manual (Page 19)

only)
NetSet Menu
The following diagram illustrates the structure and flow of the NetSet Menu on the Adtec
DPI-1200 device.
Control Function Options API
Command
Mode Defines whether a current net set
is active and able to be used or
inactive
InsertNet (Typical
Setting) Activates NetSet
for use
Inactive Setting is to to
be used for trigger
*.DPID NST #
x MODE
Days On Specifies the specific days of the
week to use the configured
NetSet
ALL (Typical Argument)
NetSet is used for all day
of the week
*.DPID NST #
x DAYSON
Type Defines the type of cue to trigger
insertion for that channel DTMF_TONE Audible
tone generated by
receiver
GPI Momentary Contact
Closure
SCHED_TIME Scheduled
timed insertion based on
schedule and clock
SCTE35 Network
Embedded Cue passed
from splicer to the DPI
*.DPID NST #
x TYPE
Start
Condition Defines the event sequence to
start the insertion process (DTMF
or GPI Only)
DTMF Cue: 123*
GPI: Closed or Open
If using SCTE35, leave
blank
*.DPID NST #
x STARTCOND
Stop
Condition Defines the event sequence to
stop the insertion process (DTMF
or GPI Only)
DTMF Cue: 123#
GPI: Closed or Open
If using SCTE35, leave
blank
*.DPID NST #
x STOPCOND
Pre-Roll Defines the time, in milliseconds,
to delay the start of an ad
insertion once a valid cue trigger
is received (DTMF or GPI Only)
0 - 9000 *.DPID NST #
x PREROLL
Post-Roll Defines the time, in milliseconds,
to delay the end of an ad
insertion back to network
0 - 7000 *.DPID NST #
x PSTROLL