Adtec digital DPI-1200 (version 01.04.08U) Manual - Manual (Page 21)

channel Splicer Interface / Site
Splicer
Chassis # Number distinction of
the Splicer Chassis
for channel
text field; 1-999 available
Consult Splicer documentation
Note: Can usually be left at 1
*.DPID SCS #
Splicer
Card #
The numeric
representation of the
physical card, on the
connected Splicer,
where the Splicer
Port connection is
made
text field; 1-10 available
(Consult Splicer documentation)
Some splicer cards may be labled
A, B, C, D or E. So, A = 1, B = 2,
etc...
*.DPID SCA #
Splicer Port
# Physical connection,
on the configured
Splicer Card, for the
insertion stream
text field; 1-20 available
(Consult Splicer documentation) *.DPID SPO #
Splice Lead
In Number of
milliseconds before
each splice point to
start the insert
text field; Valid Range is 300 -
1500 ms. *.DPID SLI #
CCMS ID # The Unique numeric
Traffic and Billing
Native Mode
Identifier for
scheduling and
verification
user-defined; numeric field in
format: xxxxx
Referred to as the CCHHH Number
*.DPID CNV C #
CCMS
Format Traffic and Billing
media/Spot ID
Format in schedule,
also referred to as
parsing format
20/20 uses 6 right-justified
characters
NOVAR uses 8 right-justified
characters
RAW uses all 11 characters
LEFT uses left-justified characters
NONZERO Omits any leading zeros
*.DPID CNV P #
Break
Repeat
Configures the
behavior for dealing
with incomplete
breaks
ON partially played break can be
triggered again, resuming with the
previously aborted spot
OFF (Typical Setting)
*.DPID BRP #
Splice
Multicast
Address
The IP Address of
which the insertion
stream is served to
the splicer via the
GigE Port.
Valid Multicast
addressing range is
224.10.XXX.XXX to
239.XXX.XXX.XXX.
A Unicast address will
be the unique IP of
user-defined; numeric field in
format: xxx.xxx.xxx.xxx *.DPID MSI #