Adtec digital DPI-1200 (version 01.04.08U) Manual - Manual (Page 20)

programming once a valid Stop
Condition is received. (DTMF or
GPI only)
Avial Time The total maximum time
available for a series of spots
played during a commercial
insertion
Hours:Minutes:Seconds
CCMS Mode 00:00:00 *.DPID NST #
x AVAIL
End By Condition which must be met
before the Splicer will switch
back to the network feed
Spot:(typical setting)
Switch back when the
spots have finished
running and a scheduled
break is completed
SpotAvail: Switch back
when the spot is finished
and the configured Avail
time is met
*.DPID NST #
x ENDBY
Note: Up to twelve Insertion Channels are available on the product. If using API
Commands, the ‘#’ denoted in the NST Commands above are relevant to the twelve channel
destinations indexed 0 - 11. The ‘x’ denoted in the Commands above represents the NetSet
Index value indexed 0 - 9. (Each channel has 10 possible netset configurations.)
Splicer Menu
The following diagram illustrates the structure and flow of the Splicer Menu on the Adtec
DPI-1200 device.
Item Function Options Adtec API
Command
Channel
Mode
Enable or disable
Splicer
communication
OFF: Turned off / disabled
ASI: ASI Streaming Channel
IP: IP Streaming Channel
*.DPID CHM #
Channel
Name Output channel name
on the Splicer for
channel
text field;
Note: Must match the name of
channel on Splicer
*.DPID CLN #
Splicer IP
Address
Management IP
Address of the
Splicer used for
channel
user-defined; numeric field in
format: xxx.xxx.xxx.xxx
*.DPID SIA #
Splicer
Name
Name of the Splicer
Interface used for
text field;
Note: Match the name of the
*.DPID SPN #