CONTA-CLIP GSM-PRO - Manual (Page 34)

GSM-PRO
- 32 -
NOTE: The min./max. and threshold/hysteresis values are limited to 5 digits with a maximum of 2
decimals.
A delay in seconds can be set which a changed AI has to exceed before it is accepted, during the delay
the UI led blinks. If the status of the delay is changed back again to the previous state before the delay
is expired the change is discarded.
Set the delay to 0 to disable detection delay.
6.3.2 6.3.2 6.3.2 6.3.2
Reading
Reading Reading Reading from from from from a aa an n n n analog input analog input analog input analog input
To retrieve the status of an analog input, send: rrrrui ui ui uin , where n is the number of the requested input.
The module answers: ‘status AIn=xxxx’
When a user defined name is given to an input it can be addressed by putting the name between
asterisks. E.g. if an output is called ‘watertank’, you read the status by sending
r* r* r* r*watertank**** . The
module answers: ‘status watertank=xxxx’
6.3.3
6.3.3 6.3.3 6.3.3 Wiring example Wiring example Wiring example Wiring example
In the following example Ai1 and Ai8 are connected to an analog source.