CONTA-CLIP CMS-UI-2UI - Manual

CONTA-ELECTRONICS
CMS CMS CMS CMS----UI UI UI UI----2 2 2 2UI UI UI UI
IIIIsolated solated solated solated S S S Signal ignal ignal ignal converter converter converter converter
Further information: www.conta-clip.com Cat. No.: 95121.7 Further information: www.conta-clip.com
Electrical specifications Electrical specifications Electrical specifications Electrical specifications Manual Manual Manual Manual
Order information Order information Order information Order information
type
CMS-UI-2UI
cat.no 16121.2
Input data Input data Input data Input data
range (select via dipswitches)
0-5V/1-5V/0-10V/2-10V/0-10mA/2-10mA/0-20mA/4-20mA
max. input signal (U / I) 12V / 25mA
input resistance (U / I) > 50 kOhm / 100 Ohm
Output data Output data Output data Output data
output signal (select via dipswitch)
0-5V/1-5V/0-10V/2-10V/0-10mA/2-10mA/0-20mA/4-20mA (and inverted out)
max. output signal (U / I) < 10,5V / < 21mA
load resistance (U / I) > 1k Ohm / < 600 Ohm
offset (U / I) < 20mV / < 40uA
General data General data General data General data
module power supply
24V DC ±25%
module current typical 65mA
conversion error < 0,5% of end value
temperature coefficient < 0,02 %/°C
max. conversion frequency 10Hz
CE marking Low Voltage Directive (LVD) 2006/95/EC, according requirements of EN 61010
EMC Directive 2004/108/EC, according requirements of EN 55011 and EN 61326-1
isolation voltage input / power 500V DC
isolation voltage input / output 500V DC
isolation voltage output / power 500V DC
operating / storage temperature 0°C…+55°C / -20°C…+70°C
conductor cross section 0,2 - 2,5 mm²
connection system screw clamp connection, pluggable
insulation stripping length 7 mm
mounting / installation position DIN-rail TS35 / any
module size LxWxH (TS35) 17,5 x 99 x 114,5mm
weight 115 gr
The CMS-UI-2UI is a multi-functional dual output 4-
way isolated signal converter. This module is used for
electrical isolation and conversion of analog signals.
The 4-way isolation enables the module to be used
locally as well as in the vicinity of the controlling
system.
The inputs and outputs of the converter are configured
by means of dipswitches.
Any combination of input and output can be chosen,
so numerous different signal conversions can be set.
Default input/output setting is 0..10V / 0..10V.
Other default input/output settings on request.
Features:
Features: Features: Features:
• Multifunctional analog inputs (0..5V, 1..5V, 0..10V, 2..10V, 0..10mA, 2..10mA,
0..20mA, 4..20mA)
• Multifunctional analog outputs (0..5V, 1..5V, 0..10V, 2..10V, 0..10mA, 2..10mA,
0..20mA, 4..20mA). The output signal can be inverted.
• Analog signal range selectable via DIP switches
• Dual output 4-way galvanic isolation
• Power supply 24V DC
• Other analog signal ranges on request
Cms-ui-ui manual rev0.fl.doc