CONTA-CLIP GSM-PRO - Manual (Page 10)

GSM-PRO
- 8 -
3.4 3.4 3.4 3.4
C
C C Co o o onnec nnec nnec nnect to PC t to PC t to PC t to PC
Connect a USB cable (artnr. 16103.2, sold separately, please contact Conta-Clip for further
information) to the mini USB socket on the module, and the other end to a USB port on a PC.
NOTE: Make sure to install the interface software and drivers before connecting the module to a PC.
3.5 3.5 3.5 3.5
LED description
LED description LED description LED description
3.5.1 3.5.1 3.5.1 3.5.1
Module status indication
Module status indication Module status indication Module status indication
After connecting the power it takes about 10 seconds before the first Led activates.
The Led ‘Run’ indicates module activity:
•
Flash = starting-up (takes about 90 seconds)
•
ON = ready for use (blinks every 10 seconds)
• OFF = no power
The Led ‘Com’ indicates network activity:
•
green ON = connected to GSM network’
•
green Flash = roaming GSM network
• green OFF = not connected to GSM network
The Led ‘Busy’ indicates module activity:
• ON = module currently busy
After data transfers between the PC and the module, the module performs a reset. During this time all
UI Led’s light up and all other Led’s are off.
3.5.2
3.5.2 3.5.2 3.5.2 IO indication
IO indication IO indication IO indication
• For each Digital Output a Led lights up when the relay is activated.
• The Universal Input Led’s light up when:
-
When set as digital input : the input is active (1)
-
When set as analog input : a top or bottom threshold is exceeded