1 update update update update – CONTA-CLIP GSM-PRO User Manual

Page 21

GSM-PRO

- 19 -

5.1

Update

The GSM-PRO can perform firmware updates remote(OTA) or when connected by USB to a PC.
O

Over T

The A

Air (OTA) covers remote actions where the data is transmitted over GPRS.

NOTE: To perform an OTA action the module has to be registered to a GSM data connection and data
usage has to be allowed (see section network settings)

5.1.1

5.1.1

Manual firmware updates

Download the latest firmware at:

http://www.conta-clip.com/en/service/

After downloading, unzip the complete folder to a location on your PC. Click the firmware update
button and the software prompts to the location of the firmware. Locate the unzipped folder and
select the GSM-PRO.jar file.

During the firmware update all UI Leds on the module light up. The firmware update takes about 2
minutes. After the update the module restarts itself.

NOTE: do NOT disconnect the module or turn off the power supply during this operation.

5.1.2

5.1.2

OTA firmware update

To remotely update the firmware send:

fotap

. The GSM-PRO downloads the online firmware, installs

it and restarts. When a firmware update is succeeded the module sends a confirmation to the sender.

To check the modules current firmware version send:

fwv

. The module answers

firmware version: .

To check if there is a newer firmware version available send:

cupd

. The module answers

name> (No) update found. Online local: .

5.1.3

5.1.3

OTA configuration

The configuration with the user interface can be performed remotely. Send:

rotac

to start this

procedure. When the command is received the module uploads the current configuration to the