CONTA-CLIP GSM-PRO - Manual (Page 30)

GSM-PRO
- 28 -
If set, the module sends a confirmation message: ‘status DOn=x‘, or when a user defined name is
given: ‘status
name =x‘
If an output state is already in the state, the text: ‘status not changed’ is added to the answer.
NOTE: see user defined functions to define own instructions.
6.1.4
6.1.4 6.1.4 6.1.4
Using the one
Using the one Using the one Using the one----shot function shot function shot function shot function
The digital outputs can be set for a given time from 1 to 36000 seconds. When this command is
received, the DO sets to 1 and after the number of seconds the DO falls back to 0. The one shot
function is called by selecting a single DO followed by a ‘t’ for time and the time in seconds. E.g.
when you send
wdo wdo wdo wdo1t10 1t10 1t10 1t10 DO1 is set for 10 seconds.
The one-shot function sends two answers, one at the start and one at the end of the sequence.
NOTE: see user defined functions to define own instructions.
6.1.5
6.1.5 6.1.5 6.1.5 Reading Reading Reading Reading from from from from multiple multiple multiple multiple digital outputs digital outputs digital outputs digital outputs
To retrieve the status of all digital outputs send: rmdo rmdo rmdo rmdo .
The module answers: ‘status DO1=x, DO2=x, DO3=x, DO4=x’
6.1.6
6.1.6 6.1.6 6.1.6
Reading
Reading Reading Reading from from from from a single digital output a single digital output a single digital output a single digital output
To retrieve the status of an individual digital output, send: rdo rdo rdo rdon , where n is the number of the
requested digital output. The module answers: ‘status DOn=x’
When a user defined name is given to a digital output it can be addressed by putting the name
between asterisks. E.g. if an output is called ‘light’, you read the status by sending
r* r* r* r*light**** . The
module answers: ‘status light=x’
6.1.7
6.1.7 6.1.7 6.1.7
React
React React React on RING on RING on RING on RING
This function enables toggling one or more DOs on a RING (phone call) command. When one of the
selected users in the settings tab dials the number of the module it toggles all selected DOs and
breaks the connection. The caller receives a SMS message with the status of the DOs.
When the output timer value is set greater than 0 the output status is set to 1 for the amount of
seconds set. If the output status is already 1 this is kept for the amount of seconds and then set to 0.
Set the output timer value to 0 to disable the timer function.
6.1.8
6.1.8 6.1.8 6.1.8 Link DO to DI
Link DO to DI Link DO to DI Link DO to DI
DO1 can be linked to DI1, DO2 to DI2 and so on. When a status change on a DI is detected the
corresponding DO will adopt this status.
The status of the DO can always be overruled by an SMS message setting the output(s)(see above). If
an output has already the same state as the linked input the output will not change.
NOTE: This function can conflict with the SMS and RING instructions.
6.1.9
6.1.9 6.1.9 6.1.9
Activate
Activate Activate Activate when GSM connection when GSM connection when GSM connection when GSM connection is is is is los los los lostttt
Select to activate an output when the GSM connection is lost. The output deactivates as soon as the
GSM connection is re-established.