CONTA-CLIP GSM-PRO - Manual (Page 26)

GSM-PRO
- 24 -
When connected, erase the event log by clicking ‘erase AI log’. Erase remote by sending: aiclr aiclr aiclr aiclr . The
module answers with a confirmation message.
5.4.3
5.4.3 5.4.3 5.4.3 IO operating hours counter
IO operating hours counter IO operating hours counter IO operating hours counter
The IO operating hours counter sums the total time the IO is in HI state. The counter can be turned
on/off each individual digital in- and output. The counted value can be added to the periodical
message and ‘RALL’(see chapter 6.5).
Counters are limited to 17500 hours.
NOTE: make sure to keep all IO’s in LO state when configuring the counters due to faults in starting
time.
5.4.3.1 5.4.3.1 5.4.3.1 5.4.3.1
Request digital output counter
Request digital output counter Request digital output counter Request digital output counter
To retrieve the counter value of an individual digital output, send: time time time timedo do do don , where n is the number of
the requested digital output. The module answers: ‘Don ON for x,xx hours’.
To retrieve the counter values of all digital outputs send:
timedo0. timedo0. timedo0. timedo0.
The module answers: ‘Do1 was ON for x,xx hours, Do2 was ON for x,xx hours … Do4 was ON for x,xx
hours’,
5.4.3.2 5.4.3.2 5.4.3.2 5.4.3.2 Request digital input counter
Request digital input counter Request digital input counter Request digital input counter
To retrieve the counter value of an individual digital input, send: timedi timedi timedi timedin , where n is the number of
the requested digital input. The module answers: ‘Di n ON for x,xx hours’.
To retrieve the counter value of all digital inputs send:
timedi0. timedi0. timedi0. timedi0.
The module answers: ‘Di1 was ON for x,xx hours, Di2 was ON for x,xx hours … Di8 was ON for x,xx
hours’.
5.4.3.3 5.4.3.3 5.4.3.3 5.4.3.3
Reset digital output counter
Reset digital output counter Reset digital output counter Reset digital output counter
To reset the counter value of an individual digital output, send: clr clr clr clrtimed timed timed timedo o o on , where n is the number of
the requested digital output. The module answers: ‘erasing counter Do n ’.
To reset the counter values of all digital outputs, send:
clr clr clr clrtimedo timedo timedo timedo0 0 0 0 . The module answers: ‘erasing
counter Do1, erasing counter Do2… erasing counter Do4’.
5.4.3.4 5.4.3.4 5.4.3.4 5.4.3.4 Reset digital input counter Reset digital input counter Reset digital input counter Reset digital input counter
To reset the counter value of an individual digital input, send: clr clr clr clrtimedi timedi timedi timedin , where n is the number of
the requested digital input. The module answers: ‘erasing counter Di n ’.
To reset the counter values of all digital inputs, send:
clr clr clr clrtimedi timedi timedi timedi0 0 0 0 . The module answers: ‘erasing
counter Di1, erasing counter Di2… erasing counter Di4’.
5.4.4
5.4.4 5.4.4 5.4.4 Monitor input changes during restart
Monitor input changes during restart Monitor input changes during restart Monitor input changes during restart
The module detects changes on the inputs while restarting. The status when is saved on restart /
power-down and will be compared on next start-up. Any changes detected are send to the
configured users.