CONTA-CLIP CMS-F-UI - Manual

CONTA-ELECTRONICS ===== = = = = = = = = =
CMS CMS CMS CMS----FFFF----UI UI UI UI
=
===== ===== ===== =====IIIIsolated solated solated solated S S S Signal ignal ignal ignal converter converter converter converter
Further information: www.conta-clip.com Cat. No.: 95120.9 Further information: www.conta-clip.com
Electrical specifications Electrical specifications Electrical specifications Electrical specifications Manual Manual Manual Manual
=
=
=
=
=
=
The CMS-F-UI is a multi-functional 3-way isolated
signal converter. This module is used for electrical
isolation and conversion of frequency to analog
signals.
The 3-way isolation enables the module to be used
locally as well as in the vicinity of the controlling
system.
The inputs and outputs of the converter are configured
by means of dipswitches.
Any combination of input and output can be chosen,
so numerous different signal conversions can be set.
Default input/output setting is 0..1,0kHz / 0..10V.
Other default input/output settings on request.
=
=
Order information Order information Order information Order information
type
CMS-F-UI
cat.no 15886.2
Input data Input data Input data Input data
range (select via dipswitches)
0-0,1Hz to 0-10kHz (see table)
max. input signal 30V
input resistance > 10 kOhm
sensor PNP/NPN, NAMUR initiator, push-pull
resolution 0,1mHz resp. 5 ppm from measured value
Output data Output data Output data Output data
output signal (select via dipswitch)
0-5V / 0-10V / 0-20mA / 4-20mA
max. output signal (U / I) < 15V / < 30mA
load resistance (U / I) > 1k Ohm / < 600 Ohm
offset (U / I) < 10mV / < 20uA
response time 350ms + two times the period of the input frequency
General data General data General data General data
module power supply
24V DC ±25%
module current Approx. 50mA
conversion error < 0,2%
temperature coefficient < 0,02 %/°C
CE marking Low Voltage Directive (LVD) 2006/95/EC, according requirements of EN 61010
EMC Directive 2004/108/EC, according requirements of EN 55011 and EN 61326-1
isolation voltage input / power 1kV, 50Hz, 1min.
isolation voltage input / output 1kV, 50Hz, 1min.
isolation voltage output / power 1kV, 50Hz, 1min.
operating / storage temperature 0°C…+55°C / -20°C…+70°C
conductor cross section 0,2 - 2,5 mm²
connection system screw clamp connection, pluggable
insulation stripping length 7 mm
mounting / installation position DIN-rail TS35 / any
module size LxWxH (TS35) 17,5 x 99 x 114,5mm
weight 120 gr
=
=
=
Features:
Features: Features: Features:
• Multifunctional frequency input (selectable from 0…0,1Hz to 0…10kHz)
• Multifunctional analog output (0..5V, 0..10V, 0..20mA, 4..20mA).
• Frequency input and analog signal output range selectable via DIP switches
• 3-Way galvanic isolation
• Power supply 24V DC
• Other analog signal ranges on request
Cms-f-ui manual rev0.fl.doc