CONTA-CLIP GSM-PRO - Manual (Page 29)

GSM-PRO
- 27 -
6.1.2 6.1.2 6.1.2 6.1.2 Select Select Select Select users users users users
The recipients have access to the associated digital output.
NOTE: Selected DO users do not have any rights to send other commands to the module other than
addressed to the defined output.
6.1.3
6.1.3 6.1.3 6.1.3 Messaging
Messaging Messaging Messaging
It is possible to send self made instructions or use the pre-defined instructions per output or as a
group as described in the next chapters.
With these instructions an output can be activated, deactivated and activated for a given period of
time (one-shot).
6.1.3.1 6.1.3.1 6.1.3.1 6.1.3.1
Number ID
Number ID Number ID Number ID
The number ID for setting a digital output can be disabled per output. When disabled the output
responds on both SMS and incoming calls (see 6.1.3.6) from everyone.
NOTE: keep safety precautions in mind when disabling this function together with the ring function
due to unwanted incoming calls.
6.1.3.2 6.1.3.2 6.1.3.2 6.1.3.2 User defined instructions User defined instructions User defined instructions User defined instructions
Use a self made instruction to control an output. E.g. you may want to use the instruction pumpon to
activate output 1, and pumpoff to deactivate.
In this way the multiple outputs can also be controlled by configuring the same instruction for
another output.
It is also possible to combine functions with one instruction. E.g. activate an output, deactivate
another, activate the one-shot on a third and so on.
6.1.3.3 6.1.3.3 6.1.3.3 6.1.3.3 Writing to multiple digital outputs Writing to multiple digital outputs Writing to multiple digital outputs Writing to multiple digital outputs
To set all Digital outputs send the default message: w w w wmdo mdo mdo mdoxxxx
Each x represents the state of its positions output: 0=off, 1=on, 2=don’t change and 3=toggle.
E.g. when you send
wmdo wmdo wmdo wmdo0123 :
•
DO1 sets to 0
•
DO2 sets to 1
•
DO3 is not changed
•
DO4 toggles its state (0 to 1 or 1 to 0)
The module sends a confirmation message with the output states only to the sender: ‘status DO1=x,
DO2=x, DO3=x, DO4=x’
NOTE: see user defined functions to define own instructions.
6.1.3.4 6.1.3.4 6.1.3.4 6.1.3.4 Writing to Writing to Writing to Writing to a a a a single digital output single digital output single digital output single digital output
To set an individual digital output (DO) send the following default message: wdo wdo wdo wdonx , where n= the
output number and x is the state.
E.g. when you send
wdo wdo wdo wdo31, DO3 is set to 1.
When a user defined name is given to an output, it can be addressed by putting the name between
asterisks. E.g. if an output is called ‘light’, you can set it by sending
w* w* w* w*light****3 , this output will be
toggled.