2 wastewater connection, Ole_link5 – BINDER KMF 115 User Manual
Page 26
KMF (E5.3) 07/2014
page 26/98
4.2 Wastewater connection
Fasten the wastewater hose to the wastewater connection “OUT” (11) on the rear of the unit (olive ∅ 14
mm). Observe the following points:
•
You can use a part of the supplied water hose as a drainage hose. In case another hose is used, it has
to be permanently resistant against at least 95 °C / 203 °F.
•
Mount the wastewater hose with a maximum positive inclination of 1 m and a maximum total length of
3 m.
•
Protect both ends of the drainage hose with two of the four supplied hose clamps.
Waste water is collected in an internal can with a volume of approx. 0.5 liters. It is pumped off
only when required, thus there is no continuous waste water flow.
(22)
(9)
(12) (11)
(9)
Power cable
(11) Wastewater connection “OUT” with hose
olive for hose ½“
(12) Freshwater connection “IN” with screw
thread ¾’’ for hose ½“, with union nut
(22) Socket for optional freshwater can (chap.
Figure 9: Rear view KMF with water connections
Protect the waste water supply at both sides with the supplied hose clamps.