Altera Mentor Verification IP Altera Edition AMBA AXI4-Stream - Manual (Page 33)

SystemVerilog Master BFM
Master BFM Configuration
Mentor Verification IP AE AMBA AXI4-Stream User Guide, V10.3 33
April 2014
A master BFM has configuration fields that you set by calling the set_config() function to
configure timeout factors, setup and hold times, and so on. You get the value of a configuration
field using the
get_config() function. Table 3-2 describes the full list of configuration fields.
1.
Refer to Master Timing and Events for details of simulator time-steps.
Table 3-2. Master BFM Configuration
Configuration Field Description
Timing Variables
AXI4STREAM_CONFIG_SETUP_TIME The setup-time prior to the active
edge of ACLK, in units of
simulator time-steps for all
signals.
1
Default: 0.
AXI4STREAM_CONFIG_HOLD_TIME The hold-time after the active
edge of ACLK, in units of
simulator time-steps for all
signals.
1
Default: 0.
AXI4STREAM_CONFIG_BURST_TIMEOUT_FACTOR The maximum delay permitted
between the individual transfer
transactions in clock cycles.
Default: 10000.
AXI4STREAM_CONFIG_MAX_LATENCY_TVALID_
ASSERTION_TO_TREADY The maximum delay permitted
between the assertion of
TVALID to the assertion of
TREADY. Default: 10000.
Master Attributes
AXI4STREAM_LAST_DURING_IDLE Controls the value of TLAST
during idle.
0 = TLAST driven to 0 during
idle (default)
1 = TLAST driven to 1 during
idle
Error Detection
AXI4STREAM_CONFIG_ENABLE_ALL_ASSERTIONS Global enable/disable of all
assertion checks in the BFM.
0 = disabled
1 = enabled (default)
AXI4STREAM_CONFIG_ENABLE_ASSERTION Individual enable/disable of an
assertion check in the BFM.
Refer to the
Master Assertions
chapter for details
0 = disabled
1 = enabled (default)