Pilz PMCprimo 16+.00/0/1/6/4 - Manual (Page 8)

6 Introduction
Page 8 User Manual for Motion Control Tools
6 Introduction
6.1
Installation under Microsoft Windows
The software is installed using the installation program on the "Motion Control Tools".
The CD-ROM contains an installation program which makes it easier for you to install the
software on your PC. The CD-ROM also has an "AutoPlay" function: once the CD-ROM has
been inserted, a dialogue box will open automatically, showing various selection options
(program installation, manuals, etc.). This function can also be started manually by calling up
the program minstall.exe.
Install:
Place the CD-ROM in the CD-ROM drive of your computer. After a few seconds the setup
function starts automatically, if "Autoplay" is activated. Otherwise please start minstall.exe.
Choose "Install the Motion Control Tools" and follow the on-screen instructions.
6.2 System requirements
Minimum specification for the PC:
Operating system Microsoft Windows 2000, XP, Vista or 7
Hardware Minimum requirements of operating system
Interface
One free serial interface
Ethernet interface (optional)