Pilz PMCprimo 16+.00/0/1/6/4 - Manual (Page 2)

1 General Information
Page 2 User Manual for Motion Control Tools
1 General Information
1.1 Copyright
Copyright 2012 Pilz GmbH & Co. KG. All rights reserved.
All rights reserved. The implementation of technical changes which improve the performance of
the product is subject to change without prior notification! The product or parts of the content
may be reproduced or transmitted in any form (by printing, photocopying, microfilm or any other
method) or stored, processed, copied or distributed by electronic means without the written
permission of Pilz GmbH & Co. KG.
1.2 Notice
Pilz GmbH & Co. KG reserves the right to make amendments to this document at any time.
The examples given serve only as illustrations. No guarantee is given for their suitability in
particular applications. Although the utmost care has been taken in the production of this
document, no liability can be accepted for any mistakes that it may contain. We welcome any
suggestions for the improvement of our products, or documentation.
We reserve the right to make technical changes, which lead to the improvement of the product!
1.3 Previously published editions
Version Remarks
01/01
Initial version: Valid from software version 1.03
16/05/2001 Revised version: Valid from software version 1.04
14/12/2001 Revised version: Valid from software version 2.01
V1-04-06-2002 Revised version: Valid from software version 2.03
V2-09-12-2002 Revised version: Valid from software version 2.04
V3-10-06-2003 Revised version: Valid from software version 2.05
V4-10-05-2004 Revised version: Valid from software version 2.06
V5-23-02-2005 Revised version: Valid from software version 2.07
V6-23-08-2005 Revised version: Valid from software version 2.08
V7-15-11-2005 Revision
V8-09-10-2007
Revised version: Valid from software version 3.1
V9-18-01-20008 Revised version: Valid from software version 3.2
V10-02-03-2010 Revised version: Valid from software version 3.3
V11-02-04-2012 Revised version: Valid from software version 3.4