Pilz PMCprimo 16+.00/0/1/6/4 - Manual (Page 42)

9 PScope
Page 42 User Manual for Motion Control Tools
Digital:
PMCprotego S: Status General status data for the expansion card PMCprotego S
PMCprotego S: I/O status Status of the inputs/outputs on the expansion card PMCprotego S
PMCprotego S: Error Error status of the expansion card PMCprotego S
Resolution Adjust the signal resolution for scope function
Position Shift the position of the recorded signal vertically
Colour/Line Colours and Lines Settings
Operating elements
Time Base Select the scale on the X-axis (horizontal axis) for scope function measured in ms per division.
Channel Select trigger channel
Edge Select trigger edge: Trigger function reacts on rising or falling edge (positive or negative edge)
Trigger Level Adjust Y-value for trigger function
Pre Trigger Adjust X-value for trigger function (time axis)
Trigger Mode
Single Shot One-off triggering and signal recording
Normal Continuous triggering (signal is constantly refreshed)
OFF Constant signal recording, without triggering
RUN Starts the trigger function
STOP Stops the trigger function
Motor Tuning Select one of the service functions and adjust the parameters. Then start the function by using
START button. The function will continue to be performed until you click on the STOP button.
START / STOP Starts and stops the selected service function.
Motion commands cannot be executed during active recording. The service functions are
available when the recording has finished.
Care must be taken when selecting parameters to ensure correct configuration.