Pilz PSSnet SHL 8T MRP - Manual (Page 40)

Entering the IP Parameters
PSSnet SHL - Basic Configuration
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
2.5 System configuration via BOOTP
41
2.5 System configuration via
BOOTP
When it is started up via BOOTP (bootstrap protocol), a device receives its
configuration in accordance with the "BOOTP process" flow chart
(see
fig. 13) .
Note: In its delivery state, the device gets its configuration data from the
DHCP server.
Activate BOOTP to receive the configuration data (see on page 50 „Web-
based IP configuration“) or see in the CLI:
Provide the BOOTP server with the following data for a device:
# /etc/bootptab for BOOTP-daemon bootpd
#
# gw -- gateway
# ha -- hardware address
# ht -- hardware type
# ip -- IP address
# sm -- subnet mask
# tc -- template
.global:\
:gw=0.0.0.0:\
:sm=255.255.240.0:
enable Switch to the Privileged EXEC mode.
configure protocol bootp Activate BOOTP.
copy system:running-config
nvram:startup-config Activate BOOTP.
y Confirm save..