Pilz PSSnet SHL 8T MRP - Manual (Page 145)

Network load control
146
8.6 VLANs
PSSnet SHL - Basic Configuration
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
Configuring the ports
Figure 42: Defining the VLAN membership of the ports.
Assign the ports of the device to the corresponding VLANs by click-
ing on the related table cell to open the selection menu and define
the status. The selection options are:
X - = currently not a member of this VLAN (GVRP allowed)
X T = member of VLAN; send data packets with tag
X U = Member of the VLAN; send data packets without tag
X F = not a member of the VLAN (also disabled for GVRP)
Because terminal devices usually do not interpret data packets with
a tag, you select the U setting. You only select the T setting at the
uplink port at which the VLANs communicate with each other.
Select “Write” to save your settings temporarily.
Select the Switching:VLAN:Port dialog.