Pilz PSSnet SHL 8T MRP - Manual (Page 161)

Operation diagnosis
162
9.3 Out-of-band signaling
PSSnet SHL - Basic Configuration
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
9.3.3 Monitoring the device functions via the
signal contact
„
Configuring the operation monitoring
„
Displaying the signal contact
The device gives you three additional options for displaying the status of
the signal contact:
X LED display on device,
X display in the Web-based interface,
X query in the Command Line Interface.
Select the Diagnostics:Signal Contact dialog.
Select "Monitoring correct operation" in the "Mode signal contact"
frame to use the contact for operation monitoring.
In the "Monitoring correct operation" frame, you select the events
you want to monitor.
To monitor the temperature, you set the temperature thresholds in
the Basics:System dialog at the end of the system data.
enable Switch to the Privileged EXEC mode.
configure Switch to the Configuration mode.
signal-contact 1 monitor all Includes all the possible events in the operation
monitoring.
signal-contact 1 trap enable Enables a trap to be sent if the status of the oper-
ation monitoring changes.