Pilz PSSu E S 4AI U - Manual (Page 37)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
5-5
5.3 Inserting and removing an electronic module
5 Installation
5.3.2 Removing an electronic module
Removing an electronic module 5- ][Elektronikmodul ziehen
Procedure:
 Press the locking mechanisms [1] together simultaneously.
 Pull out the electronic module [2].
Schematic representation:
][Elektronikmodul stecken und ziehen
Please note:
 Only insert on to base modules that are already installed.
 Preferably these base modules should be ready wired.
 Electronic modules with outputs may only be inserted and removed
when the load is switched off. Unforeseeable error reactions may be
triggered if modules are inserted and removed under load.
 When an electronic module is plugged into a base module for the first
time, one part of the coding element remains on the electronic mod-
ule, while its counterpart is fixed on to the base module. This is how
the base module is coded.
 The mechanics of the electronic modules are designed for 50 plug in/
out cycles.
[1]
[2]
[1]