Vortech 2006-2010 6.1L Jeep SRT8 User Manual

Page 49

P/N: 4CK020-010 v6.0, 02/17/2012

A. Reconnect the battery.

B. Locate the vehicles OBD2 connector locat-

ed below the dash on the driver’s side of

the vehicle.

C. Attach the OBD2 connector from the Flash

tool that is provided in the kit to the vehicle’s

OBD2 port. Make sure this connector is

seated all the way in the vehicle’s OBD2

port. You do not want this connector coming

out during programming or damage may

occur to the vehicle’s ECM.

D. The Reflash tool should power up and dis-

play three parameters.

1. Performance Tune

2. Diagnostics

3. Options

E. Select “Performance Tune” and press the

enter button in the middle of the arrow keys.

F. Read the disclaimer entirely, then select

agree and press ENTER.

G. At this point follow the instructions on the

screen displayed on the reflash tool. If you

have any questions, either refer to the man-

ual that is provided with the reflash tool or

contact our service department for further

assistance.

H. Turn the ignition on (do not start the vehi-

cle). Set the parking brake and press the

ENTER button to continue.

SELECT TUNE will be displayed at the top

of the screen. Use the arrow keys to select

the appropriate tune for your vehicle and

press the ENTER button. You will have a

choice of two to choose from:

1. Vortech (used for installing kit)

2. Original Backup

J. Continue to follow the screen and when fin-

ished, unplug the reflash tool from the vehi-

cle’s OBD2 port.

IMPORTANT!

To ensure trouble-free programming of your vehicle's computer:

• Make sure the vehicle's battery is sufficiently charged.

• Turn off all accessories and close doors to prevent unnecessary drain on the battery.

• Do not attempt to program your vehicle while a battery charger is connected.

• Improper battery voltage will result in failure of the programming process.

• Do not disconnect the cable or turn off the ignition during programming.

NOTE: Do not disturb the cable, or turn the ignition off during

this time. If the programming is disrupted, the comput-

er will not start or run your vehicle!

Fig. a

ESCAPE

ENTER

SELECT

ARROWKEYS

11. REFLASH COMPUTER