Vortech 2006-2010 6.1L Jeep SRT8 User Manual

Page 11

P/N: 4CK020-010 v6.0, 02/17/2012

A. Disconnect negative cable at the battery.

B. Remove the plastic engine cover and set

aside.

C. Remove the valve cover breather hose from

the factory air inlet duct. Remove the air filter

and all ducting up to the throttle body.

Unplug the IAT (Inlet Air Temperature) sensor

and remove it from the air filter housing. Set

it aside for later use.

D. Remove the radiator grille from the vehicle

(only the 6 plastic fasteners on top of the

radiator core support need to be removed to

accomplish this).

E. Remove the accessory drive belt.

PREPARATION AND REMOVAL

Fig. 1-a

Fig. 1-b

NOTE: For early model year vehicles whose coolant reservoir

tops are black colored, a reservoir adjustment is

required for proper installation clearance.

- Use the supplied spacer and M6 nut with

washer located in fuel system assembly to

space the fender mount tab away from the

inner fender (See Fig. 1-a).

- Drill another 3/16" mounting hold in the shock

tower to secure the relocated reservoir (See

Fig. 1-b).

NOTE: It is recommended that this installation be performed

when fuel level is below a quarter tank as the fuel tank

will be removed in a later step.