Vortech 2006-2010 6.1L Jeep SRT8 User Manual

Page 13

P/N: 4CK020-010 v6.0, 02/17/2012

A. Relieve the fuel system pressure

B. Disconnect the eight fuel injector plugs and

retaining clips from the injectors.

C. Remove the four screws that hold down the

fuel rail on the intake manifold. Lift up on the

rails evenly and remove all eight injectors.

D. Using a small amount of clean motor oil, light-

ly lubricate the O-rings on both ends of the

Vortech supplied fuel injectors. Install the fac-

tory injector retaining clips.

E. Install the new injectors into the fuel rails with

the terminals facing outward.

F. Carefully lower the fuel rail/injector assembly

down onto the intake manifold.

G. Check to see that each injector has been

seated properly into the intake manifold.

H. Re-install both driver side fuel rail bolts and

the front passenger side bolt. Set aside the

remaining bolt as it will be used in a later

step. Attach the injector plugs to the injectors.

FUEL INJECTOR REPLACEMENT