Martin Christ RVC 2-33 CDplus User Manual
Page 41
Rotational Vacuum Concentrator RVC 2-33 IR
6 Operation
Version 08/2009, Rev. 2.1 of 02/12/2014 • sb
41
Translation of the original operating manual
• Open the lid and remove the rotor in order to load it with the product or
insert the loaded rotor.
• Close the lid. A menu appears:
Fig. 24: Continuing the evaporation
• Continue the process by selecting "Evaporation manual" or
"Evaporation program".
Stopping the warm-up phase prematurely
During the warm-up phase, the functions "Open lid", "Continue with phase"
or "Stop warm-up" can be selected with the right-hand function key "mode".
The warm-up is stopped by selecting one of the functions.
Manual or program-controlled evaporation
If the unit is in the standby mode, the evaporation phase can be started
directly. For this purpose, select from the menu " Start with phase" the item
"Evaporation manual" or "Evaporation program".
NOTE
The function "Evaporation program" can only be selected if a program was
created before (see chapter 6.5.3.2 - "Program administration").
Stopping the evaporation process prematurely
If the timer is active, the evaporation process will be stopped automatically
when the preset time is over. The process can also be aborted manually.
• Open the menu "Select mode" with the left-hand function key.
• Select the function "Stop evaporation“.
• Press the right-hand function key to confirm.
Fig. 25: Stopping an evaporation process
When the evaporation process is stopped, the chamber is completely
aerated and the rotor stops. Then, the system inquires as to whether the lid
should be opened.
Fig. 26: Message after stopping an evaporation process
Pos: 138 /01 0 Univ ersal mod ule/Seit enwec hsel @ 0\m od_ 120 211 624 4312 _0. docx @ 10 5 @ @ 1