Martin Christ RVC 2-33 CDplus - Manual (Page 38)

Rotational Vacuum Concentrator RVC 2-33 IR
6 Operation
38
Version 08/2009, Rev. 2.1 of 02/12/2014 • sb
Translation of the original operating manual
Display (5)
The main window of the display is divided into three areas: the values
windows, the assignment of the function keys and the status bar. The main
window shows the process data, e.g. set values and actual values, menues
and process-relevant information (see figure).
6 Values window
7 Assignment of the
function keys
8 Status bar
Fig. 19: Structure of the CDplus display
Values window (6)
The value windows are displayed after the initialisation of the control
system. There are two value windows with an identical layout. The
indication of the measurement value channels is controlled by way of the
"up" and "down" keys (see above).
9 Measuring channel
10 Set value (only shown
in the run mode)
11 Unit of the measured
value
12 Actual value
Fig. 20: Values window
The available measurement values can be displayed in the values window
on the left as well as in the values window on the right so that a
combination of the following values can be selected:
• Rotor speed
• Vacuum (only if a vacuum sensor is installed)
• Safety pressure (only if a vacuum sensor is installed)
• Rotor chamber temperature
• Ice condenser temperature (only if the option "Cooling trap control" is
used)
• Total time (counts the time of the entire process run)
• Section time (counts the time of an individual phase, e.g. warm-up,
program sections)
Assignment of the function keys (7)
see "function keys" (1+2)
Status bar (8)
The status bar shows information regarding the lid status, the operating
mode, the active phase, and pending information. The status bar is visible
at all times.