EXFO BV10 Performance Endpoint Unit - Manual (Page 69)

CLI Command Reference
BV10-100 and BV10-1000 63
Configuration Commands
Interface Configuration Commands
The following commands allow setting the port interface parameters such
as the IP addressing (static IP or DHCP), auto-negotiation (speed, duplex,
flow control), VLAN support, transceiver (electrical or optical), laser (ON or
OFF), and cable (straight or auto detection).
Note: Most of the interface commands do not display output. Use the
show interface
(see page 51) and
show config
(see page 59) commands to display the
BV10’s current interfaces and configuration.
Note: For the TEST port: Duplex and Flow Control are not configurable and
respectively set to Full and None.
interface test transceiver electrical|optical
Description Sets the TEST port transceiver type to either electrical or optical.
This command applies to the BV10-1000 only.
This command cannot be sent through the Test port.
Syntax interface test transceiver electrical|optical
Example bv10-100> interface test transceiver optical
interface test laser on|off
Description Turns the laser of the TEST optical interface on or off.
This command applies to the BV10-1000 only and is available only
when the transceiver type is set to optical.
This command cannot be sent through the Test port.
Syntax interface test laser on|off
Example bv10-100> interface test laser on