EXFO BV10 Performance Endpoint Unit - Manual (Page 64)

CLI Command Reference
58 BV10
Configuration Commands
Configuration Commands
BV10 Configuration commands allow to view and change the configuration
of the BV10.
The Configuration commands are organized into the following subgroups:
Subgroup Command Page
General show config 59
Console password set password
password clear
console telnet|ssh server enable|disable
console in-band enable|disable
console in-band port port_value
console telnet|ssh|serial idle-timeout value_in_seconds
61
61
61
62
62
62
Interface
Configuration
interface test transceiver electrical|optical
interface test laser on|off
interface lan|test speed auto
interface test speed 10|100|1000 auto
interface test speed 10|100|1000 force
interface lan speed 10|100 force
interface test speed 1000 auto
interface lan duplex auto
interface lan duplex half|full
interface lan flow auto
interface lan flow rx|none
interface lan|test cable auto
interface test cable straight
interface lan|test vlan value|none
interface test vlan priority value
interface lan|test address-netmask IP_address/netmask|dhcp
interface lan|test gateway IP_address|none
interface lan|test gateway dhcp|none
63
63
64
63
64
65
65
65
66
66
66
67
67
67
67
68
68
69