EXFO BV10 Performance Endpoint Unit - Manual (Page 45)

BV10-100 and BV10-1000 39
7 CLI Command Reference
This chapter describes the BV10 command line interface (CLI). The
commands are grouped under Operation and Configuration commands.
Note: When the BV10 is used in a BrixWorx environment, you must use BrixWorx
GUI rather than CLI prompt to manage the BV10 device. When you change
a reflector to run or not through the CLI, this is not updated on the BrixWorx
GUI Additional Services page. The GUI changes override the changes done
using the CLI prompt.
Note: Refer to Introducing the BV10 CLI on page 29 for more information on CLI
and its features.
Conventions
The following table lists the conventions used in this chapter to represent
command syntax.
Command Availability
All CLI commands can be sent through the LAN and CONSOLE ports. Only
a subset of commands can be sent through the Test port.
Convention Description Example
Pipe symbol | Choice between two
or more parameters.
all | lan | test
Select one of the keywords:
all
,
lan
or
test
.
Square brackets [ ] Optional parameters. [timeout value_in_ms]
The timeout parameter and its
value
value_in_ms
are optional.
Italics Variable information.
size size_in_bytes
Enter a number in place of
size_in_bytes
.